This is not a gas, this is water

BB three-dimensional atomized fireplace 3D fireplace abandons the traditional electric fireplace design concept and does not require any imaging screen. It also uses LED lights as the light source. The almost realistic dynamic flames "burn" directly from the wood pile and directly generate flames in the air. , the flames rise up with the surrounding air flow and are lifelike. The "smoke" and "flame" are perfectly integrated to achieve a three-dimensional flame simulation effect. No smoke or any dust pollution.

[What is the use of 3D fireplaces? 】

The function of 3D fireplace is to provide ornamental decoration. If it is well designed, it can also add heating function at the same time.

[Principle of 3D fireplace]

The principle of the mist fireplace is to use ultrasonic waves to create mist from water, and then use the air duct system to design a suitable flow rate, and then use lights to map out a simulated three-dimensional fake 3D flame out of thin air, which is lifelike.

[How to install a mist fireplace? 】

Surface-mounted and wall-mounted 3D fireplaces can be placed directly exposed to the outside, but concealed-mounted atomizing fireplaces need to make an installation pit in advance, with sockets pre-placed inside. Do not install the sockets at the bottom of the pit to prevent Wet due to accidental water spillage.

A 15mm high air inlet should be left at the bottom of the pit directly in front. The air inlet is connected to the open space directly in front. The length of the air inlet is the same as the furnace core. The purpose is to allow cold air to flow in and circulate out from the upper part. The flame is upright, elegant and natural, and more dynamic. If there is no way to open an air inlet in the installation pit, you need to reserve multiple exhaust holes on the ceiling of the fireplace itself, or supplement it with a speed-adjustable exhaust device on the building directly above the fireplace.

There must be no negative pressure in the pit to suck the air outward (otherwise the flame will be sucked back and not flow upward). If the fireplace has a good fire shape outside the pit and the flame is put into the pit to suck the flame back, the problem of the draft in the pit must be solved first. to install!

After the 3D fireplace is installed, other objects such as stone, glass, steel plates, etc. cannot be pressed down for the sake of aesthetics. It must be easy to take out the entire fireplace for future maintenance and repair. Otherwise, such an unreasonable and willful design is extremely inappropriate and subsequent work The quantity is large and extremely troublesome. A multi-million dollar luxury car may break down, let alone just a fireplace.

For more information please contact us.

E-mail : peter@bbfires.com

Hong Kong Tel: 852-69318059

weixin：13714791523

Peter Ma